Kia Magentis 2009 User Manual download pdf (Page 103)

437

Features of your vehicle

Standard programming

To train most devices, follow these

instructions:

1. For first-time programming, press and

hold the two outside buttons,

HomeLink

®

Channel 1 and Channel 3

Buttons, until the indicator light begins

to flash (after 20 seconds). Release

both buttons. Do not hold the buttons

for longer than 30 seconds.

2. Position the end of your hand-held

transmitter 2-8 cm (1-3 inches) away

from the HomeLink

®

buttons while

keeping the indicator light in view.

3. Simultaneously press and hold both

the HomeLink

®

and hand-held trans-

mitter button.DO NOT release the but-

tons until step 4 has been completed.

4.While continuing to hold the buttons

the red Indicator Status LED will flash

slowly and then rapidly after

HomeLink

®

successfully trains to the

frequency signal from the hand-held

transmitter. Release both buttons.

5.Press and hold the just-trained

HomeLink

®

button and observe the red

Status Indicator LED. If the indicator

light stays on constantly, programming

is complete and your device should

activate when the HomeLink

®

button is

pressed and released.

6.To program the remaining two

HomeLink

®

buttons, follow steps 2

through 5.

Rolling code programming

Rolling code devices which are "code-

protected" and manufactured after 1996

may be determined by the following:

• Reference the device owner's manual

for verification.

• The handheld transmitter appears to

program the HomeLink

®

Universal

Transceiver but does not activate the

device.

• Press and hold the trained HomeLink

button.The device has the rolling code

feature if the indicator light flashes rap-

idly and then turns solid after 2 sec-

onds.

To train rolling code devices, follow these

instructions:

1. At the garage door opener receiver

(motor-head unit) in the garage, locate

the "learn" or "smart" button. This can

usually be found where the hanging

antenna wire is attached to the motor-

head unit. Exact location and color of

the button may vary by garage door

opener brand.

If there is difficulty locating the training

button, reference the device owner's

manual or please visit our Web site at

www.homelink.com.

2. Firmly press and release the "learn" or

"smart" button (which activates the

"training light").

✽✽

NOTICE

There are 30 seconds in which to initiate

step3.

3. Return to the vehicle and firmly press,

hold for two seconds and then release

the desired HomeLink

®

button. Repeat

the "press/hold/release" sequence a

second time to complete the program-

ming. (Some devices may require you

to repeat this sequence a third time to

complete the programming.)

4.Press and hold the just-trained

HomeLink

®

button and observe the red

Status Indicator LED. If the indicator

light stays on constantly, programming

is complete and your device should

activate.

5.To program the remaining two

HomeLink

®

buttons, follow either steps

1 through 4 above for other Rolling

Code devices or steps 2 through 5 in

Standard Programming for standard

devices.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 325 326

Comments to this Manuals

No comments